Kenwood TK-2312 Service Manual page 11

8. Mounting the Chassis to the Case
Assembly
1. Confirm that the waterproof packing attached to the
circumference of the chassis is securely inserted in the
groove of the chassis q.
2. Insert the upper part of the chassis into the case assem-
bly w.
3. Press the chassis e and the case assembly together to
attach them.
Caution: If the packing of the SP/MIC does not come
to the correct position after attaching the chassis to the
case assembly, reposition the packing with your fi ngers.
9. Attaching the Antenna Receptacle to
the Chassis
Screw the antenna receptacle to the chassis in the order
shown in the drawing so that the antenna receptacle
comes to the center of the case hole.
Tighten this screw second
DISASSEMBLY FOR REPAIR
Tighten this screw first.
TK-2312/2317
10. The Nuts of the Volume Knob and
Channel Knob
Note that the shapes, colors and heights of nuts of the
volume knob and channel knob are different from one
another. (The nut of volume knob is silver, and the nut of
channel knob is gold)
Use the following jig when removing the nuts of the vol-
ume knob and channel knob.
• Jig (Part No.: W05-1012-00)
for Volume knob
(Long)
11. Screw sequence for mounting the TX-
RX unit to the chassis
Attach the TX-RX unit to the chassis using the screws in
the order shown in the drawing below.
TX-RX UNIT
Conponent side view
for Selector knob
(Short)
11