Instruction
Outdoor Unit
1. Air filter
2. Air-Purifying Filter with photocatalytic
3. Air inlet
4. Front panel
5. Panel tab
6. INTELLIGENT EYE sensor:
7. Display
8. Air outlet
9. Flap (horizontal blade): (page 12)
10. Louvers (vertical blades):
11. Operation lamp (green)
12. TIMER lamp (yellow): (page 20)
13. HOME LEAVE lamp (red):
18. Air inlet: (Back and side)
19. Air outlet
20. Refrigerant piping and inter-unit cable
Appearance of the outdoor unit may differ from some models.
76
Indoor Unit
deodorizing function
•
These filters are attached to the inside of
the air filters.
•
It detects the movements of people and
automatically switches between normal
operation and energy saving operation.
(page 18)
•
The Louvers are inside of the air outlet.
(page 12)
•
Lights up when you use HOME LEAVE
Operation. (page 16)
Outdoor Unit
14. Indoor Unit ON/OFF switch:
•
Push this switch once to start operation.
Push once again to stop it.
•
The operation mode refer to the following
table:
Mode
Temperature
FTKS
COOL
FTXS
AUTO
•
This switch is useful when the remote
control is missing.
15. Packaging materials: 50 class only
•
If any packaging materials are included,
please remove before operating. (page 24)
16. Room temperature sensor:
•
It senses the air temperature around the
unit.
17. Signal receiver:
•
It receives signals from the remote control.
•
When the unit receives a signal, you will
hear a short beep.
•
Operation start .............beep-beep
•
Settings changed..........beep
•
Operation stop..............beeeeep
21. Drain hose
22. Earth terminal:
•
It is inside of this cover.
SiEN04-306D
Air flow
setting
rate
22°C
AUTO
25°C
AUTO
System Configuration