Initial Setup Configuring The Wfs709Tp As A Dhcp Server - NETGEAR WFS709TP Quick Start Manual

Initial Setup Configuring the WFS709TP as a DHCP server

NOTE: Most existing networks will have already a device offering IP addressing via DHCP, be sure to that
no other device is offering this service before you configure your Wireless Controller as a DHCP server,
as having two DHCP servers in the same network will cause network communication issues.
With a computer directly connected to the WFS709TP, change the computer's IP address manually so it
is in the same default IP subnet that the WFS709TP uses – which is 192.168.0.0/24. The default IP
address of the WFS709TP is 192.168.0.250
Open a web browser, and access the initial configuration page via the IP address of the wireless
controller – here you can set up the basic configuration parameters:
For this example we'll use these values, but you can change them to match your current IP scheme. Note
that if you set your controller to a different subnet you will need to change your PC's IP address to match.