JVC CS-DA1 Instructions Manual page 11

Procedures for vertical installation
1
Mount mounting brackets A and
B at the bottom of the unit
Mounting bracket B
Mount such
that the letter
ABB is at the
bottom.
2
Tighten screws on mounting
bracket C and mount it in the car
Mounting bracket C
Mounting screw
(Dia. 7/32 inch c 1 inch /
M 5 mm c 25 mm) c 2
Assemble two mounting brackets C.
Tapping screw
/ M 4 mm c 20 mm) c 8
Use the paper pattern to determine the
position and mount the unit in the car.
Mounting screw
(Dia. 7/32 inch c 11/32 inch
/ M 5 mm c 8 mm) c 4
Mounting
bracket A
Mount such
that the
letter AAB is
at the
bottom.
(Dia. 3/16 inch c 13/16 inch
3
Make a hole in the carpet and
secure the mounted mounting
brackets C with butterfly nuts
Mounting bracket C (c2)
assembled in step 2
Use the paper pattern to determine the
positions.
Attach the cushion when the back of the unit
comes into contact with the car.
CAUTION
Be sure to check the positions of piping,
tanks and electrical wiring and do not
interfere or touch these items when making
holes in the car to mount the unit. Treat the
machined areas with anti-rust and
waterproof measures.
If left untreated, they may cause traffic
accidents or fire.
Cushion
Peel off the
sheet
Butterfly nut
(Dia. 7/32 inch /
M 5 mm) c 4
Spring washer
(Dia. 7/32 inch /
M 5 mm) c 4
Carpet etc.
Use a cutter
to make 4
holes.
7