Setting The Switches - JVC TK-C215VP12U/E Instructions Manual

Installation and Connection

Setting the switches

Remove the dome cover, followed by setting the
video image switches.
1.
Removing the dome cover
Remove the dome cover by unfastening the 3
fastening screws using the wrench supplied.
Memo:
● The dome cover and base are connected
with fall prevention wire.
Fall Prevention
Wire
*TK-C215VP4U/E is used in the above illustration
2.
Removing the inner dome
The inner dome is fastened using clips at 3
different positions. Grasp the inner dome and
remove it from the clips.
Note:
● Before touching the camera unit, make sure
to touch the metal surface of the [MONITOR]
terminal to discharge any static electricity
from your body. Static electricity may cause
the camera to malfunction.
3.
Set the switches for video images.
(APg. 12 Setting the Switches and the Lens
(TK-C215VP4U/E) )
(APg. 14 Setting the Switches and the Lens
(TK-C215VP12U/E) )
Wrench (Supplied)
*TK-C215VP4U/E is used in the above illustration
Setting the switches
2
Clip(x 3)
Inner
Dome
3
LL PHASE
O
1
N
2 2
3
4 4
5
WHT.
6
BAL.
7
8