Operating Instructions; Start Up - Scotsman TC 180 Service Manual

Page 7

START UP

After having correctly installed the ice maker and
completed the plumbing and electrical connec-
tions, perform the following "Start-up" procedure.
A. Open the water supply line shutoff valve and
give power by moving the main switch, on the
power supply line, to the ON position.
The GREEN LED will glow to signal that unit is
under power.
NOTE. Every time the unit is put under power,
after being kept for sometime in shut-off
conditions (electrically disconnected) the 2nd
RED LED will blink for 3 minutes (Fig.1).
FIG. 1
FIG. 2

OPERATING INSTRUCTIONS

B. Elapsed the 3 minutes - stand by period - the
unit starts operating with the activation in
sequence of the following assemblies:
GEAR MOTOR
COMPRESSOR
FAN MOTOR kept under control by the condenser
temperature sensor which has its probe within
the condenser fins
with the switching off of the 2nd RED LED
(Fig. 2).
C. Elapsed 2 or 3 minutes from the compressor
start up, observe that flaker ice begins dropping
off the ice spout to fall into the storage bin.
Page 7