Table of Contents
Advertisement
INSTALLATION
1.
Before temporarily installing the new part, apply
body sealer to the wheel arch.
NOTE:
1)
Apply sealer about 5 mm (0.20 in.) from the
flange, avoiding any oozing.
2)
Apply evenly, about 3 - 4 mm (0.12 - 0.16 in.) in
diameter.
3)
For other sealing points, refer to AR.
INSTALLATION DIAGRAM
Describes in detail installation of the new part involving repair by welding and/or cutting, but exclud-
ing painting.
INSTALLATION GUIDE
Provides additional information to more efficiently help you perform the installation.
SYMBOLS
See page
IN-4
.
ILLUSTRATION of WELD POINT
Weld method and panel position symbols.
See page
IN-5
.
INTRODUCTION
BODY PANEL REPLACEMENT-Rear Body Components
Butt Weld
Body Sealer
Body Sealer
About 5 mm
2.
RE-35
Braze
mm
in.
5
0.20
Temporarily install the new part and check fit for
the rear door, luggage compartment door and
rear combination light.
IN-3
Hide quick links:
Advertisement
Table of Contents
