Presetting Ws Broadcasters And Radio Stations; Clearing Ws Broadcaster Presets - JVC FR-DS100 Instructions Manual

Presetting WS broadcasters and radio
stations
20 stations in each radio band and 20 broadcasters in
the WS band can be preset. Radio bands can be
preset either automatically or manually. WS band
broadcasters must be manually preset.
To preset stations automatically (radio
bands only)
This function scans a selected band (AM (MW/SW),
FM) and can automatically store up to 20 presets in
memory for each band.
1
Press BAND to select the frequency band.
2
Press the AUTO PRESET button to enter the
automatic memory mode.
The MEMORY and the PRESET indicators blink in
the display. If no buttons are pressed for 5
seconds, the mode is exited.
AUTO PRESET
=
3
Press PRESET–/ PRESET+ to select the preset
number to begin memorizing presets at.
4
Press the AUTO PRESET button again.
The search begins automatically at the currently
selected frequency.
5
When a broadcasting signal is found, the search
pauses and the signal is received for 5 seconds.
At the end of this time, a preset for that
frequency is memorized and the search
continues for the next preset. However, if the
AUTO PRESET button is pressed during this time,
a preset is not memorized and the search
continues to the next available frequency.
When the search is finished, the last preset
frequency stored is tuned.
Notes:
• When the AUTO PRESET function is performed, presets
previously stored will be replaced by the new presets.
• If the signal of a station is not strong enough, the search
may not stop at that frequency when using the AUTO
PRESET function. When this occurs, tune to the station
manually and store the preset using the manual preset
method shown on the next column.
12
BAND
AUTO STEREO MEMORY
PRESET
PRESET
AUTO PRESET
To preset stations and WS broadcasters
manually
This function is necessary to preset WS broadcasters
or radio frequencies that require manual tuning to be
received.
1
Select the station or WS broadcaster program to
be preset.
2
Press MEMORY/CANCEL.
The MEMORY indicator lights in the display and
the PRESET indicators blinks.
MEMORY
WS
/ CANCEL
=
3
Press the PRESET–/PRESET+ buttons to select a
preset location.
If neither button is pressed for 5 seconds, the
MEMORY indicator disappears from the display
and the mode is exited.
4
Press MEMORY/CANCEL again to memorize the
preset.
The preset is stored in memory, and the mode is
exited.

Clearing WS broadcaster presets

If you move from one WorldSpace service area to
another, broadcasters that were previously preset
may no longer be received. Follow the procedure
described below to clear broadcaster preset
information in the unit.
While the unit is on, press and hold the WS button
and then the button for 2 seconds until "INITIAL"
appears in the display. All WS band broadcaster
presets are cleared. Radio station presets are
maintained in memory. Press the
the unit to standby and then on again to complete
the procedure.
WS
AUTO STEREO MEMORY
PRESET
PRESET
MEMORY
/ CANCEL
button to turn
+