Outbound On Front Course For Procedure Turn To Loc Approach Using Dg - Honeywell KAP 140 Pilot's Manual

Single Axis Operation

Outbound On Front Course For Procedure Turn To LOC Approach Using DG

D.C. ELEC.
TURN COORDINATOR
L R
2 MIN.
NO PITCH
INFORMATION
PUSH
G
KAP 140
AP HDG NAV APR
1. The aircraft is heading 270° with heading
engaged. To intercept and fly the LOC front
course outbound, set the front course on the
OBS and depress the back course (REV) but-
ton. While the HDG annunciation is flashing
move the heading bug to the front course 058°.
Since HDG was active upon selection of REV,
the autopilot will initiate a 45° intercept to the
localizer. In this case, the aircraft will turn to
283°.
38
N
TO
A
V
GS
FR
OBS
ı
REV
KAP 140 AUTOPILOT SYSTEM
D.C. ELEC.
TURN COORDINATOR
L R
2 MIN.
NO PITCH
INFORMATION
PUSH
G
KAP 140
AP HDG NAV
2. When the computed capture point is reached,
auto-intercept mode is cancelled, the reverse
localizer mode is automatically activated and a
left turn outbound on the localizer is initiated by
the autopilot.
Note: The left-right deviations of the CDI course
deviation needle are reversed (you must turn right
to center a deviation of the index to the left). This
needle reversing takes place because you are fly-
ing outbound on a front course.
N
TO
A
V
GS
FR
OBS
ı
APR REV
Rev. 1
Apr/02