Table of Contents
Advertisement
Troubleshooting (Cont.)
Symptom
During video replay,
video image
sometimes is
disturbed
Image color is poor or
image is disturbed
Specific colors fail to
be displayed
The upper part of the
• While computer system signal is input,
video image bows or
distorts.
The projection
position on the screen
has shifted.
Video image suddenly
• Aren't video turned off by pressing the
go out.
62
Probable cause
• have Installation adjustment been
performed?
• Is picture quality (color desity, etc.)
adjusted correctly?
• Is the correct broadcast system (color
system) selected?
• Are signals (scanning frequency, etc.)
to connected devices appropriate?
• Is the source setting correctly selected?
Isn't a wrong source (forced mode)
selected?
• Are specifications of the signal being
input matching those of the video input
card?
• Is the input cable connected correctly?
• Has the lamp's life come to its end?
isn't a sync signal for composite sync
(Cs) or G on sync being input?
• Isn't signal with much jitter or skew
distortion being input to a video deck?
• Is the source setting correctly selected?
Isn't a wrong source (forced mode)
selected?
• Have the channel's setup contents
been changed?
• Have the channel's setup contents
been changed?
• Is sync signal being input correctly?
• Has the projector been moved from its
installed place?
remote control's AV HIDE button?
• Are all color video signals being input? • Check signals and connections.
Corrective action
• For installation, consult the dealer
where you purchased the projector or a
local service center.
• Adjust picture quality on the menu.
• Set the broadcast system (color
system) to AUTO.
• Check if the signal is appropriate
(scanning frequency, etc.), and input
the appropriate signal.
• Set the source setting to AUTO. If the
problem still persists, set it to the
correct dedicated source (forced
mode).
• Check specifications of both signal
being input and video input card.
• Check cable connections.
• Check the used lamp hours on the
menu, and if the lamp life is near its
end, consult the dealer where you
purchased the projector or a local
service center.
• Input separate sync signals for vertical
sync (V) and horizontal sync (H)
signals.
• Input signals with little jitter or
distortion.
• Set the source setting to AUTO. If the
problem still persists, set it to the
correct dedicated source (forced
mode).
• Check the setup contents been
changed.
• Check the setup contents of the
channel and correct them if necessary.
• Check sync signal and related
connection.
• Check the installed position.
• Press the remote control's AV HIDE
button to turn video on.
Page
––––
38, 40
34
19
44 ~ 46
––––
21
60
10
––––
44 ~ 46
47 ~ 51
47 ~ 51
10
––––
12
19 ~ 23
Advertisement
Table of Contents
