Advertisement
I
RM-M150 REMOTE CONTROL UNIT
The Quick Alignment function automatically adjusts (sets)
the screen settings of the image input from the PC1 or PC2
input terminals. This can only be performed from the remote
control.
While projecting an image on the screen, press the QUICK
ALIGN. button on the remote control.
Quick alignment is conducted to obtain best image.
Q u i c k A l i g n m e n t
• This only works for the signals input from the PC1 or PC2
input terminals. It does not work for the signals input from
the AV IN terminal (VIDEO or Y/C input terminal).
• The quick alignment function is used to automatically adjust
the "Brightness", "Contrast", "Horizontal and vertical
position", "Phase" and "Tracking" of the projected image.
• When using the quick alignment function to automatically
adjust the image, use a bright, still-picture. It may not
function correctly on a dark or motion picture. If the results
obtained with the quick alignment function are not
satisfactory, manually adjust the "Brightness", "Contrast",
"Horizontal and vertical position", "Phase" and "Tracking" of
the projected image.
I
5 ∞ 2 3
RM-M150 REMOTE CONTROL UNIT
While projecting an image, a still picture is obtained at any
time by using the FREEZE button on the remote control.
"FREEZE" appears on the screen for a few seconds and
then the still picture is shown on the screen. Refer to the
FREEZE message shown on the left of this page.
The original image resumes.
• During freezing, the picture sent from the signal source is
lost.
• If any of the inoperative buttons ("MENU", "QUICK ALIGN.",
"KEYSTONE") are pressed while displaying a still picture,
"FREEZE" is displayed on the screen.
• This function will not work with some signal sources
(UXGA, etc). In this case, the FREEZE inhibit message
appears for a few seconds, as shown on the left. To forcibly
clear this message, press the EXIT button.
A part of the image being projected can be digitally magnified up
to four times. When the DIGITAL ZOOM T or W button is
pressed, "Digital zoom" appears on the screen together with the
level bar and magnifying power (×1.0, ×1.2, ×1.4, ×1.6, ×2.0,
×2.5, ×3.2, ×4.0). When "15 sec." is displayed in the menu,
"Digital zoom" will appear in approximately 15 seconds.
Digital zoom
1.2
• To zoom up or zoom down, press the DIGITAL ZOOM T or
W button on the remote control.
While "Digital zoom" appears on the screen, you can move
the zoomed image with the cursor (5/∞/2/3) button on the
remote control.
5: Upper part of the image will be
displayed.
∞: Lower part of the image will be
displayed.
2: Left side part of the image will
be displayed.
3: Right side part of the image
will be displayed.
• This function will not work with some signal sources
(UXGA, etc). In this case, the DIGITAL ZOOM inhibit
message appears for a few seconds, as shown on the left.
To forcibly clear this message, press the EXIT button.
• The quality of the zoomed image reduces in comparison
with the original one.
• To return to the original size (×1.0) and original position,
press the PRESET button while "Digital zoom" is displayed
on the screen.
Advertisement
