POWR
1
CONNECTING RODS AND PISTONS
SERVICE POINTS
Connecting rod and piston removal
The following procedure applies to all of the
connecting rods and pistons.
1. Remove:
• Connecting rod cap 1
• Big end bearings
NOTE:
Identify the position of each big end bearing so
that it can be reinstalled in its original place.
2. Remove:
• Piston pin clips 1
• Piston pin 2
• Piston 3
• Connecting rod 4
CAUTION:
Do not use a hammer to drive the piston
pin out.
NOTE:
• For reference during installation, put identifi-
cation marks on the piston crown.
• Before removing the piston pin, deburr the
piston pin clip's groove and the piston's pin
bore area.
5-86
E