MINOR REPAIRS
Replacing a Bulb
DIP/MAIN BEAM HEADLAMPS (Fig. 40 and 41)
They are fitted with bulbs: 12 V - 45/40 W.
To take the headlamp out: remove the screw (1), then tilt the unit
forward.
To replace a bulb:
Disconnect the black plastic connector (2) carrying the feed leads.
Fig. 40
Swing the springs (3 and 4), which hold the bulb flange (5) in place,
through 90°.
Headlamps
Change the faulty bulb and fit the new one by turning the flange
1 - Retaining screw
until the locating lug falls into its slot.
Do not forget to clip over springs (3 and 4) and to reconnect the
connector (2).
To refit the headlamp unit (Fig. 42)
Position the lugs (1 and 2) opposite the white plastic buttons (3 and
4).
Pivot the unit and refit it into the headlmap housing. Fit and tighten
the screw (1 - Fig. 40).
We recommend that you have your headlamp beam checked by a
specialist every time a bulb is changed.