Honda HRX537HYEA Owner's Manual page 7

NOTICE
Fuel can damage paint and plastic. Be careful not to spill fuel when
filling your fuel tank. Damage caused by spilled fuel is not covered
under warranty.
Remove the tank cap [1] and
check the fuel level. Refill the tank
if the fuel level is low. Refuel
carefully to avoid spilling fuel. Do
not overfill; there should be no fuel
in the filler neck [2].
After refueling, tighten the fuel tank
cap securely.
Move the mower at least 3 meters
away from the fueling source and site before starting the engine.
Air Cleaner Inspection
Remove cover [1]. Make sure the filter [2] is clean and in good
condition. A dirty air filter will restrict air flow to the carburetor,
reducing engine performance. Refer to page 14 for air cleaner
service.
Handlebar Height Adjustment
Handlebar height can be adjusted to three positions: high [1], middle
[2], and low [3].
1. Turn the handlebar adjust knobs [5] 90 degrees into the unlock [7]
position.
2. Move the handlebar [4] up or down, so the locating pins align with
either the higher, middle, or lower holes on the handlebar
mounting brackets [6].
3. Turn the adjust knobs 90 degrees into the lock position [8] and the
pins will snap into the holes and lock into position.
[2]
[1]
[4]
[5]
[6]
[7]
Grass Bag
A lawn mower works like a vacuum cleaner; it blows air through the
bag, which traps the grass clippings. Always empty the grass bag
before it becomes filled to the limit of its capacity. Bagging
performance will diminish after the bag becomes about 90% filled.
Also, the bag is easier to empty when it is not packed full.
[1]
Inspection
During normal use, the grass bag material is subject to deterioration
and wear.
[2]
NOTICE
Frequently inspect the grass bag for tears, holes, and excessive wear.
Check for necessary replacement. Make sure the new bag meets the
original specifications.
If the grass bag needs replacement, you can remove and install a bag
yourself (page 16).
Installation
1. Raise the discharge
guard [1], and use
the grass bag handle
[3] to hook the grass
bag [2] onto the
mower deck as
[1]
shown.
2. Release the
discharge guard to
secure the grass
bag.
Removal
1. Raise the discharge
guard, grasp the
grass bag handle,
and remove the
grass bag.
2. Release the discharge guard.
3. When the grass bag is clear of the discharge guard, you can lift it
through the handlebar opening, or you can remove it to the rear of
the mower below the handlebar.
Cutting Height
Check the mower deck cutting
height settings, and be sure that
all four adjustment levers [1] are
[2]
set to the same cutting height
[3]
position.
To adjust cutting height, pull
each adjustment lever [1]
toward the wheel, and move it
into another notch.
If you are not sure what cutting
height to select, start with a
high setting and check the
appearance of the lawn after
mowing a small area. Then
[8]
readjust cutting height if
necessary.
ENGLISH
[1]
[3]
[2]
[1]
[1]
20 mm
32 mm
46 mm
62 mm
75 mm
88 mm
100 mm
7