3. STACK menu settings
Set up Intelligent Stack settings in the STACK menu.
• If you are using Simple Stack without an RS-232 connection, skip this
NOTE
chapter.
• If you do not need to change the settings made during the installation process
described in the previous chapter, go to
( 15 )
• Read
3.7 Important information for Intelligent Stack
3.1 Displaying STACK menu
Use the ▲/▼/◄/► buttons to go into the fol-
lowing menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu will appear on screen.
setting for Intelligent Stack operation starts from this menu.
NOTE
• Check that the following settings are made on both projectors.
Otherwise, the STACK menu on the projectors cannot be selected. ( 5 )
- STANDBY MODE in SETUP menu: NORMAL
(Operating Guide
- COMMUNICATION TYPE under COMMUNICATION in SERVICE menu: OFF
(Operating Guide
- STACK LOCK in SECURITY menu: OFF ( 5 )
(Operating Guide
→
SETUP
menu)
→
OPTION
menu)
13
3.3 Selecting lamp operation
carefully. ( 20 )
mode.
→
menu) The
OPTION