Transmitter/Receiver - MULTIQUIP MAYCO C30HDZ Installation & Operation Manual

The defi nitions below describe the controls and functions of the Miratron
Transmitter and Radio Control Receiver (Figure 7).
Transmitter
1.
Power On Switch
transmitter. Be sure to place this switch in the OFF position when the system
is not in use.
2.
Status LED Indicator
and active. LED will double-blink when battery strength is low.
3.
E-STOP Switch
pumping will cease.
4.
Belt Clip — If desired the transmitter can be placed on a belt.
5.
Pump ON/OFF Switch
begin pumping. Place the switch in the OFF position to stop pumping.
6.
Batteries
rechargable batteries are to be used, nickel-metal hydride (NiMH) are
recommended.
Receiver (Learn Button)
Transmitter and receiver must be matched as a pair. Perform the procedure
listed below to pair the transmitter and receiver. Reference Figure 7.
1.
Place the ignition switch in the ON position.
2.
Verify that the status LED on transmitter blinks (active).
3.
Place the pumping control switch on the control box in the REMOTE ON
position.
4.
Press and hold the learn button on the RX4 radio control receiver. While
keeping the learn button depressed, toggle the pump ON/OFF switch for
10 seconds.
INSTALLATION/OPERATION MANUAL — REV. #0 (09/09/09) — PAGE 15

TRANSMITTER/RECEIVER

— Place this switch in the ON position to turn on the
— Status LED blinks to indicate transmitter is ON
— When activated will cause the engine stop and all
— Place this switch in the pump ON position to
— Transmitter requires four AA 1.5V alkaline batteries. If