Wall Or Under-Table Mounting - HP 2530-24 Installation And Getting Started Manual

Installing the Switch
Installation Procedures
W A R N I N G
C a u t i o n
2-12

Wall or Under-Table Mounting

You can mount the HP 2530 24-port and 48-port switches on a wall with either
the front or rear panel facing up. The HP 2530 8-port switches must be
mounted on a wall with the network ports facing up.
For safe operation, do not install the switch with side ventilation or
fan ducts facing up or down.
The switch should be mounted only to a wall or wood surface that is at least
1/2-inch (12.7 mm) plywood or its equivalent.
To mount the HP 2530 24-port and 48-port switches, follow these steps:
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 8-mm M4 screws.
2. Attach the switch to the wall or wood surface with two 5/8-inch number
12 wood screws (not included).
Wall
Figure 2-5. Wall mounting the 24-port and 48-port switches
RJ-45 Ports
wood screws
5/8-inch