Table of Contents
Advertisement
14
Height of the bottom feed dog
.09
Requirement
With the stitch length set at „0" and the needle bar 0.6 mm after its TDC (hole 1) the feed
dog must:
1. be centered in the needle plate cutout, when viewed from the side and from the
direction of feed.
2. be at its upper point of reversal and touching the adjustment gauge along its entire
length.
1,16
x
Fig. 14 - 08
Move the feed dog carrier 1 (screw 2) in accordance with requirement 1.
Allow the presser foot to rest on the gauge.
Turn eccentric 3 (screw 4) and eccentric 5 (screw 6) in accordance with requirement 2.
3
4
0,72
x
=
Take care that eccentrics 3 and 5 are not turned 180°.
Adjustment
1
6
5
2
14 - 9
Advertisement
Table of Contents
