Driveline Attachment -(Figure Asm-0008)
Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a
shield. Entanglement in rotating shafts can kill.
.
1. Attach the slip clutch end of the driveline to the
gearbox input shaft securely. Make certain that
the slip clutch is fully onto the input shaft
splines. Tighten the locknuts (2) alternately
until they have reached the proper torque.
Refer to Torque Chart in the Maintenance
Section.
SLIP CLUTCH SHIELD ASSEMBLY (FIGURE
Asm-R-0091)
To attach the Slip Clutch Shield, follow the
procedures listed below.
1. Guide shield bracket (2) through weldment
shield (1) so that bracket stud screw potrudes
through weldment hole and retain in place with
wingnut (3).
2. Align holes of shield bracket with gearbox holes
positioned around input shaft. Retain bracket to
gearbox with three 3/8" x 3/4" bolts (6), 3/8"
washers
(4),
and
Position hardware as follows:
bracket, flatwasher, lockwasher, bolt. Tighten
bolts to recommended torque.
TW6072 05/05
© 2005 Alamo Group Inc.
ASSEMBLY
3/8"
lockwashers
(5).
gearbox,
Assembly Section 3-6