Dealer Setup Instructions; Shield Assembly (All Models); Driveline Attachment - RHINO TW30 Series Operator's Manual

DEALER SETUP INSTRUCTIONS

Set up mower as received from factory with these instructions.
This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely
assembled before tightening hardware. Refer to bolt torque chart in Maintenance Section. All bolts are Grade 5
unless otherwise specified.
1. Position on flat surface.
2. Apply light oil to gear box input shaft.
The Components of these machines are quite heavy. Block all components up securely
before working under or putting extremities under such parts.

SHIELD ASSEMBLY (All Models)

SLIP CLUTCH SHIELD
1. Insert four M8x20 flange bolts through shield
into gearbox front face. Tighten bolts to
recommended torque.
2. Clip chain, if present, from driveline to shield.

DRIVELINE ATTACHMENT

Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a
shield. Entanglement in rotating shafts can kill. Figure Asm-R-0090
Attach slip clutch end of the driveline to the gearbox
input shaft securely. Make certain that the slip
clutch is fully onto the input shaft splines. Tighten
the locknuts (2) alternately until they have reached
the proper torque. Refer to Torque Chart in the
Maintenance Section.
TW30 Series 11/19
© 2020 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-2