Yard Machines 769-06354 Operator's Manual page 16

Adjustments
Auger Control
Refer to the Assembly & Set-up section for instructions on
adjusting the auger control cable.
Chute Assembly
Refer to the Assembly & Set-up section for instructions on
adjusting the chute assembly.
Skid Shoes
Refer to the Assembly & Set-up section for instructions on
adjusting the skid shoes.
Drive Control
When the drive control is released and in the disengaged "up"
position, the cable should have very little slack. It should NOT be
tight.
NOTE: If excessive slack is present in the drive cable or if the snow
thrower's drive is disengaging intermittently during operation,
the cable may be in need of adjustment.
Check the adjustment of the drive control as follows:
1. With the drive control released, push the snow thrower
gently forward. The unit should roll freely.
2. Engage the drive control and gently attempt to push the
snow thrower forward. The wheels should not turn. The
unit should not roll freely.
If any of the above tests failed, the drive cable is in need of
adjustment. Proceed as follows:
1. Loosen the lower hex screw on the drive cable bracket. See
Fig. 6-3.
2. Position the bracket upward to provide more slack (or
downward to increase cable tension).
3. Retighten the upper hex screw.
4. Repeat Drive Control Test to verify proper adjustment has
been achieved.
16 S 6 — M
ection aintenance
Fig. 6-3
& a
djuStMentS
Off-Season Storage
If the snow thrower will not be used for 30 days or longer, follow
the storage instructions below.
1. Lubricate the machine as instructed earlier in this section.
2. Store in a clean, dry area.
3. If storing the snow thrower in an unventilated area,
rustproof the machine using a light oil or silicone to coat
the snow thrower.
4. Clean the exterior of the engine and the snow thrower.
IMPORTANT: When storing unit or when it is not being serviced,
it is to remain in the operating position with both wheel and
auger housing on the ground.
NOTE: Refer to the Engine Operator's Manual for information on
storing your engine.