PEUGEOT 406 Owner's Manual page 101

ESP Electronic Stabili-
ty Programme opera-
tion indicator light
This flashes when the system is
operating.
It is lit continuously if disarmed or if
there is a fault.
Clogging of the partic-
ulate emission
warning light (diesel
engine)
Display of this warning light is
accompanied by an audible signal.
The flashing of this light while the
engine is running is caused either by
the particulate emission filter being
overloaded or by the engine running
too long at idle (white smoke from
the exhaust). There is a risk of the fil-
ter clogging if the same conditions of
operation are maintained.
As soon as possible, drive for at
least three minutes at a speed
exceeding 37 m.p.h. (60 km/h), if
driving conditions allow this.
If the light comes on, contact a
PEUGEOT dealer as soon as possi-
ble.
01-07-2002
YOUR 406 COUPE IN DETAIL
Handbrake, low brake fluid level and electronic brake force
distribution warning light.
This comes on each time the ignition is switched on.
It indicates either:
– that the handbrake is on or has not been released correctly,
and when coupled with the central (STOP) warning light:
– an excessive drop in the brake fluid level (if the light remains on even with the
handbrake released),
– lit at the same time as the ABS warning light, it indicates a malfunction of the
electronic brake force distribution system.
filter
Stop immediately.
Contact a PEUGEOT dealer.
Anti-lock braking system (ABS) warning light
This comes on for 3 seconds each time the ignition is switched on.
If it comes on at over 8 m.p.h. (12 km/h), it indicates a malfunction of
the ABS.
However, the vehicle retains conventional servo-assisted braking.
Contact a PEUGEOT dealer.
Front brake pad wear warning light
For your safety, have the pads replaced as soon as this light comes on.
105