Recommended Sae Viscosity Grades - HALE HP 100 Operation And Maintenance Manual

TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
Change oil using the following
procedures:
1. Place the pump assembly in a
work area where access can be
made to the oil drain fitting. Ensure
the pump is level. Disconnect
Negative battery cable to prevent
accidental starting of the pump.
2. Place container under oil drain
fitting to catch waste oil as it drains
from the pump.
OIL DRAIN FITTING
PORTABLE PUMPS
USER OPERATION AND MAINTENANCE
3. The oil drain fitting is a hex fitting
with a pipe plug. Use adjustable
wrench to hold hex fitting while
removing the pipe plug with an allen
wrench.
4. Once all oil is drained from the
crankcase replace pipe plug in oil
drain fitting and tighten with allen
wrench.
NOTE: Dispose of waste oil in
accordance with local
ordinances.
5. Remove oil fill cap on valve cover
or dipstick and place on a clean
surface.
6. Using a funnel to prevent spills, refill
crankcase with the proper grade of
oil.
NOTE: The engine will require
a minimum of 3 pints (1.4 liters)
if the oil filter is not replaced
and 3.5 pints (1.6 liters) if the oil
filter is replaced.
7. Check oil level and replace
dipstick or oil fill cap.
8. Reconnect negative battery
cable. Start pump and run for 30
seconds. Shut down the pump and
HP SERIES
33