Table of Contents
Advertisement
Remote
1. Unpack the stereo and all included cords.
Note: First determine where the units will be located, then connect all cables.
2. Plug the SYSTEM CONTROL cord (D) from the main unit into the SYSTEM CON-
TROL cord (E) from the satellite unit.
3. Plug one end of the audio cable (C) into the AUDIO jack on the back cabinet
of the main unit and the other end into the AUDIO jack on the satellite unit.
4. Plug the FM wire antenna (A) into the FM ANT jack on the back cabinet of the
main unit. For best results, fully extend the wire antenna and hang the circular
end from a nail in the wall.
5. Plug the single cord (B) from the subwoofer unit into the SUBWOOFER OUT
jack on the back cabinet of the satellite unit.
6. To select either 12- or 24-hour clock mode, slide the 12H/24H TIME switch
on the back cabinet of the main unit to the desired mode.
Note: To reset the unit to the alternate clock mode at a future time, you must first
unplug the unit from the wall outlet, slide the 12H/24H TIME switch on the back
cabinet to the alternate setting and then plug the unit back into the wall outlet.
7. For use in the USA or Canada, slide the AM FREQ SETUP switch to 10 kHz.
For use in other areas, slide the AM FREQ SETUP switch to 9 kHz.
8. Plug the small end of the DC power cord into the DC IN jack on the back
cabinet of the satellite unit and the large end into a wall outlet.
Stereo Setup
REPEAT
MEMORY
TUNE
TUNE
DN
UP
VOLUME
EQ
FUNCTION
Stereo Setup
Advertisement
Table of Contents
