Volvo S80 Owner's Manual page 156

04 Driver support
Adaptive cruise control*
Operation
04
Steering wheel keypad and display.
Standby mode ceases and the stored
speed is resumed.
Cruise control - On/Off or Standby mode.
Time interval - Increase/decrease.
Activate and adjust the speed.
Selected speed (in brackets = Standby
mode).
4
Time interval - On (during adjustment).
Time interval - On (after adjustment).
Activating and setting the speed
To set the Cruise control:
4 The display shows either "dash" symbol [6] or [7] - they are never shown simultaneously.
*
154
Option/accessory, for more information, see Introduction.
•
Press the steering wheel button
the symbol illuminates in the display.
The display's symbol (---) shows that the
cruise control is set in standby mode.
To activate the Cruise control:
•
At the desired speed - press the steering
wheel button or .
> The current speed is stored in the memory
- the display's symbol (---) changes to
show the selected speed, e.g.
brackets.
When the symbol
to the radar sensor has
detected a vehicle.
Only when the symbol
(with car) is illuminated, is the
distance to the vehicle in
front regulated by the cruise control.
Changing the speed
To change the stored speed:
•
Adjust with short presses on
every press gives +/- 5 km/h. The last
presses made are stored in the memory.
If speed is increased using the accelerator
-
pedal prior to pressing the
then it is the car's current speed when the
button is pressed that is stored in the
cruise control.
•
In active mode the button
function as
increase in speed: + 1 km/h.
NOTE
100
, without
If any of the Cruise Control buttons are held
down for more than approx. 1 minute, it is
blocked and disabled. To be able to reacti-
changes
vate Cruise Control, the car must be stop-
ped and the engine restarted.
In certain situations, cruise control cannot
be activated. Then the display shows
Cruise control Unavailable
page 160.
or -
/ button,
has the same
but results in a lower
, see