System Operation Information - Rheem R95P User's Information Manual

SYSTEM OPERATION INFORMATION

1. Keep the air filters clean. Your heating system will operate
more efficiently and provide better heating, more economi-
cally.
2. Arrange your furniture and drapes so that the supply air regis-
ters and the return air grilles are unobstructed.
3. Close doors and windows. This will reduce the heating load
on your system.
4. Avoid excessive use of exhaust fans.
5. Do not permit the heat generated by television, lamps, or ra-
dios to influence the thermostat operation.
6. If you desire to operate your system with constant air circula-
tion, consult your thermostat manual or please ask advice
from a qualified installer, service agency or the gas supplier.
During the heating season the operation of the warm air furnace is
automatic. Your qualified installer, service agency or the gas sup-
plier has provided a wall mounted thermostat which is sensitive to
the change in temperature of the air moving around the thermo-
stat. Your thermostat will have switches to select some or all of the
following functions:
HEAT - Turns heating on when temperature drops below the de-
sired temperature.
COOL - Turns cooling on when temperature rises above the de-
sired temperature.
AUTO - Turns cooling or heating system on as required to main-
tain the desired temperature.
OFF - Turns heating and cooling modes off. (The blower may still
circulate air in the FAN-ON position.)
FIGURE 2
BURNER COMPARTMENT - SHOWING LOCATION OF GAS CONTROLS
4
FAN-ON - Turns the blower on for continuous operation.
FAN-AUTO - The blower cycles on and off with cooling or heating
operation.
OPERATING INSTRUCTIONS
1. STOP! Read all safety information.
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance does not have a pilot. It is equipped with an ig-
nition device which automatically lights the burner. Do not try
to light the burner by hand.
5. Remove burner access door.
6. Turn manual gas control knob clockwise or set the gas con-
trol switch to the "OFF" position. See Figure 5A or 5B.
7. Wait five (5) minutes to clear out any gas. If you then smell
gas, STOP! If you don't smell gas, go to the next step.
8. Turn on gas to main burners by turning the manual gas con-
trol switch to the "ON" position.
9. Replace the burner access door. Be sure that attachment
screws are tight.
10. Turn on all electric power to the appliance.
11. Set the thermostat to desired setting.
12. If the appliance will not operate, follow the instructions "To
Turn Off Gas To The Appliance" and call your service techni-
cian or gas supplier.
FIGURE 3
BURNER COMPARTMENT - SHOWING LOCATION OF GAS CONTROLS
ST-A1194-07
ST-A1194-08