Remington i-LIGHT PRO User Manual page 9

ENGLISH
Treat desired area(s) with the i-Light device
Prepare your skin for treatment
1. Ensure the area to be treated is clean and free from oils, deodorants,
perfume, make up, lotions and creams. Shave the hair from the area to
be treated.
2. Never use wax, epilation, tweezers, or depilation products to remove the hair
because they counteract the IPL process.
Prepare the device for treatment
3. Unwrap the hand piece cord from the i-Light base and rest the hand piece in
the base cradle. Locate the power switch on the i-Light base and ensure the
unit is OFF. Connect the power cord to the i-Light base at the power inlet.
Connect the power cord to the wall outlet. Turn the power switch ON (fig 6).
4. Use the skin sensor to unlock the unit.
You must unlock the unit on each body part you wish to treat.
5. Select the desired intensity level.
Treat desired area(s) with the i-Light device
The i-Light device is equipped with two operating modes: Single Flash Mode and Multi-Flash Mode. Your
i-Light device will automatically be set to Single Flash Mode each time the device is powered ON.
Single Flash Mode: The i-Light device will flash once when the Flash Button is pressed AND the skin
contact sensor is engaged.
Multi-Flash Mode: The i-Light device will flash once every 2 seconds when the Flash Button is pressed AND
the skin contact sensor is fully engaged.
The Multi-Flash mode allows you to quickly treat large areas such as the legs, chest or back by simply
gliding the hand piece to a new location after each flash
IPL6000_IB_BOOK_UK_ONLY.indd 9
.
9
1/12/11 14:55:49