Troubleshooting - Remington i-LIGHT PRO User Manual

ENGLISH
Do not use petroleum-based or flammable cleaning agents because of the risk of fire. Never use
scouring pads, abrasive cleaning agents or aggressive liquids such as oil or acetone to clean the unit.
Troubleshooting / storage / maintenance
i-Light Device Maintenance
CAUTION: Before performing maintenance on your i-Light device, ensure that the power switch
is OFF and the power cord is disconnected from the base unit.
Replacing the bulb
1. Press the nose cone release buttons and gently pull to remove the nose cone.
2. Gently pull out the old bulb cartridge.
3. Replace with a new bulb cartridge. Replacement model: SP-6000 SB
CAUTION: When replacing the bulb cartridge, do not touch the flash bulbs directly as this leaves
oils and residue. Doing so could reduce the effectiveness of the bulbs or cause them to crack
during treatment.
4. Replace the nose cone, making sure it snaps into place.
Storage
• Switch off the unit, unplug it and let it cool down for 10 minutes before storage.
• Store the unit in a dry place at a temperature between 15º C and 35º C.

Troubleshooting

Always read these instructions fully before using i-Light.
Refer to this troubleshooting guide if you experience any problems with i-Light, as this section addresses
the most common problems you could encounter with i-Light.
If you have followed the instructions in this section and continue to experience problems, please contact
the Remington® Service Center for further assistance.
I turn the power switch ON, but the unit is not working:
• Make sure the unit is plugged into a working electrical outlet.
• Try switching to a different outlet.
The unit appears to have cracks or is broken:
• Do not use if the unit is damaged. If you have concerns about using the unit, discontinue use and
contact the Remington® Service Center for further assistance.
12
IPL6000_IB_BOOK_UK_ONLY.indd 12 1/12/11 14:55:50