Adjusting Rinse Aid Reservoir; Adding Of Salt - Kenwood KDW8ST2A User Manual

adjusting rinse aid reservoir

The rinse aid reservoir has six settings. Both the recommended set-
ting and the factory setting is "4. " (Fig b on page 16)
If the dishes are not drying properly or are spotted, adjust the dial
to the next higher number until your dishes are spot-free.

adding of salt

If the water in your area is hard, de-
posits will form on your dishes and
utensils. As such, this appliance con-
tains a salt reservoir for you to reduce
the hardness of the water.
Please follow the steps below to pour
the salt into the salt reservoir and it
must be set to correspond to the wa-
ter hardness level in your area.
1. Remove the lower basket and un-
screw the reservoir cap. (Fig 1)
. Fill the reservoir with approximate-
ly 500ml of water (first use only).
3. Place the funnel provided over the
salt reservoir. (Fig )
4. Pour in approximately 1.kg of
dishwasher salt depending on the
brand used.
5. Clean any excess salt from around
the reservoir opening and then
screw the cap on again firmly.
6. Run the "rapid" wash programme
immediately (without any crockery
in the dishwasher) to remove any
traces of salt from the compart-
ment.
Kenwood KDW8ST2A_IB_GB_Final_09017 17
open
open
1
open

GB-17
28/08/09 12:31:00 PM