Advertisement
3. To sync the device in High Security Mode, press
either the ON, OFF, 1, or 2 button ONCE, until the
panel beeps indicating receipt.
4. To sync the second serial number of the wireless key
with the receiver, simultaneously press and hold the
1, 2, 3, and 4 buttons until the panel beeps. For
LYNXR Series controls proceed to step 6.
5. To sync the device in High Security Mode, press the
3 or 4 button ONCE, and hold until the panel beeps
indicating receipt.
Note: If no beep is heard, exit Go/No Go mode, and repeat
Steps 1 - 5.
6. Exit Go/No Go mode by entering user code + 1 (OFF).
USING TWO RECEIVERS IN HIGH-SECURITY MODE
If the control supports two receivers and you plan to
use them in the high-security mode perform the
following:
1.
Enroll the transmitters into the receivers one at a
time, by disconnecting Receiver #2, and enrolling
as described in "Activating High Security Mode".
2.
Disconnect Receiver #1, reconnect Receiver #2,
and repeat the enrollment procedure. This
process ensures proper High Security operation
with both receivers.
Temporarily disable the receivers' supervisory
zones while enrolling, to prevent them from going
into "trouble" when disconnected. After enrolling,
re-enable the supervisory zones.
REPLACING THE BATTERY
The LED will not flash during transmission if the
battery is low. Replace the battery as follows.
1. Remove the case back by using the blade of a small
screwdriver to pry it open.
2. Insert the blade of a small screwdriver as shown in
Figure 2.
SPECIFICATIONS
Unit Dimensions:
2.2 in (55mm) x 1.5 in (37mm) x .5 in (12.7mm)
Battery:
Panasonic CR2032, Maxell CR2032, Duracell DL 20325, or Varta CR2032 only
FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM, REFER TO THE
INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES AND RSS210 OF INDUSTRY CANADA. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. THE USER SHALL NOT
MAKE ANY CHANGES OR MODIFICATIONS TO THE EQUIPMENT UNLESS AUTHORIZED BY THE INSTALLATION AND SETUP GUIDE.
‡K5760V2SŠ
K5760V2 7/06 Rev. A
3. Twist the screwdriver to release the battery.
4. Carefully remove the battery.
5. Press and hold any button for at least two seconds.
6. Insert a new battery in the case back location as
7. Close the case by snapping the case (front and
8. Press any button and verify that the LED flashes.
FCC AND INDUSTRY CANADA STATEMENT
INSERT
SCREWDRIVER
BLADE HERE
Figure 2 – Removing the Battery
shown in Figure 3. Positive (+) end must face
up. Use Maxell CR2032, Duracell DL 20325, or
Varta CR2032 lithium battery only.
Improper installation will result in damage
to the battery.
back) together.
Do not remove the printed circuit board.
INSERT THIS
END FIRST
Figure 3 – Installing the Battery
165 Eileen Way, Syosset, New York 11791
Copyright © 2006 Honeywell International Inc.
www.honeywell.com/security
5805-010-V0
INSTALL UNDER THIS TAB
AND ATOP THIS TAB
NOTE
POSITIVE (+) SIDE
MUST FACE UP
5805-008-V2
Advertisement
