Other Ap 7161 Power Options - Motorola AP 7161 Installation Manual

AP 7161 Access Point Installation Guide
When connecting Ethernet cable from the DATA PWR OUT port on the PoE unit to the AP 7161 GE1/POE port, a properly rated
RJ45 connector is required. One Weatherproof RJ45 plug kit is provided with each access point. When connecting cables to the
AP 7161 Ethernet ports, follow the instructions in the connector packaging and tighten the connectors to create a weatherproof
seal. Shielded cables are required.

Other AP 7161 Power Options

In addition to the PoE unit, the AP 7161 Access Point can be powered using any of the following approved Motorola controllers
that support 802.3AT PoE:
• RFS 4000
• RFS 6000
• RFS 7000
• NX 9000
The AP 7161 can also be connected directly to a Motorola Solutions controller if it is located within 100 meters of the controller
and a PoE port is available. If the CAT5E cable used to connect the radio and the controller has to travel through a building
egress, a suitable lightning protection system must be deployed (see
NOTE When using controllers, the total power limits for the AP 7161 must be considered.
The two radio configuration draws less power than a three radio configuration. If
insufficient power is available, the software will disable the third radio and throttle
back performance on all radio and Ethernet interfaces.
Ethernet and Lightning Protection on page
31
12).