Start Up Sheet - York YZF Installation Manual

Outdoor split-system heat pump 16/18 seer 2 to 5 tons
Table of Contents

Advertisement

SECTION XII: START UP SHEET
Print Form
Start-Up Date
Technician Performing Start-Up
Owner Information
Name
City
Equipment Data
Indoor Unit Model #
Indoor Coil Model #
Outdoor Unit Model #
Filter, Thermostat, Accessories
Filter Type
Thermostat Type
Connections -- Per Installation Instructions and Local Codes
Unit is level
Supply plenum and return ducts are connected and sealed
Gas piping is connected (if applicable)
Condensate drain for indoor coil properly connected
Electrical: Line Voltage
Indoor unit (volts AC)
Ground wire is connected
Electrical: Low Voltage
Heat anticipator is set to the recommended value listed in the Installation Instructions
Low voltage values: "R" and "C" at Indoor unit control board (volts AC)
Supplementary Heating Set-Up
Heating Type
Electric Air Handler
Inlet Gas Pressure (in. w.c.")
Calculated input in btuh - clock the gas meter (Nat Gas Only)
Electric Heat Kit Part # (if applicable)
Venting (if applicable)
Intake Size
Exhaust Size
Johnson Controls Unitary Products
Heat Pump and Supplementary Heat Start-Up Sheet
Proper start-up is critical to customer comfort and equipment longevity
State or Province
Upflow
Downflow
Filter Size
Other System Equipment and Accessories
Outdoor unit (volts AC)
Polarity is correct (120vac indoor units) black is L1 (hot), white is N (neutral)
Thermostat wiring complete
Natural Gas
Manifold Gas Pressure (in. w.c.")
KW installed
Venting system properly sized, within the limitations of the charts in the installation instructions.
# of 90 Degree Ells
# of 90 Degree Ells
Installing Contractor Name
Address
Horizontal Left
Indoor Unit Serial #
Indoor Coil Serial #
Outdoor Unit Serial #
Filter Location(s)
Refrigerant piping complete and leak tested
Vent system is connected (if applicable)
Condensate drain for furnace (if applicable)
Overcurrent Protection Breaker / Fuses Amperes
"R" and "C" Outdoor unit control board (volts AC)
LP Gas (Requires LP Conversion Kit)
LP Gas Conversion Kit Part # Used
LP Kit Installed By
Rated BTU/H (furnaces)
# 0f 45 Degree Ells
# 0f 45 Degree Ells
835966-UIM-E-0814
Reset Form
Zip or Postal Code
Horizontal Right
Heat anticipator
recommended value
Length
Length
Continued on next Page
27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents