Onkyo HT-S790 Instruction Manual page 55

Advanced Setup
7
Use the Down [
select "Surr Back," and use the
Left and Right [
select Small, Large, or None.
Small: Select if the surround back
speakers are small.
Large: Select if the surround back
speakers are large.
None: Select if no surround back
speakers are connected.
Notes:
• If the Surround setting in step 6 is set
to None, this setting does not appear.
• If the Surround setting in step 6 is set
to Small, the Large option cannot be
selected.
8
Use the Down [
select "Surr Back Ch," and use
the Left and Right [
tons to select 2ch or 1ch.
2ch: Select if two (left and right)
surround back speakers are
connected.
1ch: Select if one surround back
speaker is connected.
Note:
• If the Surround and Surr Back set-
tings in steps 6 and 7 are set to None,
this setting does not appear.
Continue with step 9 of the "Crossover
Frequency" setting.
Crossover Frequency
This setting only applies to the speakers that you speci-
fied as Small in the "Speaker Configuration" on page 54.
To get the best bass performance from your speaker sys-
tem, you need to set the crossover frequency according
to the size and frequency response of your speakers
9
Use the Down [
select "Crossover," and then use
the Left and Right [
tons to select a crossover fre-
quency.
Use the diameter of the smallest
speaker in your system when choosing
the crossover frequency.
] button to
]/[ ] buttons to
] button to
Notes:
• For a more accurate setting, look up the frequency
]/[ ] but-
• Choose a higher crossover frequency if you want more
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left and right
channels to the subwoofer. This function can be set only
if the Subwoofer setting (step 3) is set to Yes, and the
Front setting (step 4) is set to Large in the Speaker Con-
figuration on page 54.
10
] button to
]/[ ] but-
11
Speaker cone
diameter
Over 8 in.
(20 cm)
6-1/2 to 8 in.
(16–20 cm)
5-1/4 to 6-1/2 in.
(13–16 cm)
3-1/2 to 5-1/4 in.
(9–13 cm)
Under 3-1/2 in.
(9 cm)
*Choose the setting suitable for the speaker.
Continue with step 10 of the "Double
Bass" setting below.
response in the manuals supplied with your speakers
and set accordingly.
sound from your subwoofer.
Use the Down [
select "Double Bass," and then
use the Left and Right [
buttons to select:
On: Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
Off: Double Bass function off.
Press the [SETUP] button.
Setup closes.
SETUP
Crossover
frequency
40/50/60Hz*
80Hz
100Hz (default)
120Hz
150/200Hz*
] button to
]/[ ]
55