Table of Contents
Advertisement
Refer to the table below to check the condition. If you think that there is a problem, contact
the JVC Service Center where you purchased the television.
PROBLEMS
There is no power
The power lamps do
not light even though
the TV is on
There is no picture or
sound
Remote control is not
operating properly or
at all
You cannot select a
certain channel
The power turns off
by itself
It does not operate
correctly
The clock is wrong
The color quality is
poor
There are line across
the picture
The picture is spotted
- Check for a blown fuse or circuit breaker or a power outage.
- Check that the plugs on the power cords from the TV and receiver are
connected to wall outlets.
Check that POWER INDICATOR in the MENU is not set to OFF.
- The antenna could be disconnected.
- The input mode could be set improperly. See page 56.
- The tuner (AUTO TUNER SETUP) could be set improperly. See page 35.
- The TV station may be having difficulties. Check to see if other stations
are working.
- Check to see that the batteries are still working and properly installed.
- Make sure the remote has a clear sight path to the TV.
- Check that the TV/CATV switch is in the proper position.
- You may be too far from the TV. You must be within 23 feet (7 meters).
- Use the remote control while pointing it at the screen.
- Make sure the channels have been programmed. See "Channel
Summary" on page 35.
- Check to see if the channel is locked. See "Channel Summary - Lock"
page 36.
- Make sure the set did not become unplugged.
- Perhaps the ON/OFF TIMER is set. See page 53.
- Check to see if the Sleep Timer was set. See page 59.
This television is operated by a microprocessor. It is possible that external
noise or interference is causing the problem. If the television does not
function correctly, remove the power plugs of the TV and Receiver from
the wall outlets and wait a while before inserting them into the wall outlets
again and operating the television.
The power was interrupted and the clock was not reset. See page 52.
- Tint and Color may be improperly adjusted. See page 49.
- The VIDEO STATUS mode may be turned to the wrong setting. See
page 58.
There could be interference from another electrical appliance, such as a
computer, another TV or VCR. Move any such appliances further away
from the TV.
There could be interference from a high-wattage appliance, like a hair
dryer or vacuum, operating nearby. Move the antenna away from the
appliance or change to a coaxial cable connection which is less prone to
interference.
Troubleshooting
CHECK
63
Advertisement
Table of Contents
