Chapter 3. Disassemble and Assemble
3-1. Remove the Stand
1. Lay down the unit so that back cover faces
upward
2. Remove the five screws from the back
cover which are indicated with the circles in the
picture above.
3. Remove the stand
3-2. Remove the Back Cover
1. Remove the ten screws indicated (See
picture right.)
2. Then remove the back cover from the
unit.
3-3. Remove the Adhesive Tape
The location of the adhesive tape is shown
below.
Remove the adhesive tape.
3-4. Remove the Terminal Bracket
Remove the six screws indicated by the red
circles in the picture. (See next page.)
Service Manual
Model No.: HL42XLE2
11