Power Windows - Mercedes-Benz 500 SL Owner's Manual

Power Windows

Power window switches located on
center console.
Turn key in steering lock to
position 2.
Press switch in to resistance point:
to close
to open
Release switch when window is in
desired position.
Warning!
When closing the windows, be sure
that is no danger of anyone being
harmed by the closing procedure.
When leaving the vehicle, always
remove the key from the steering
lock, and lock the vehicle. Do not
leave children unattended in the
vehicle, or with access to an
unlocked vehicle. Unsupervised use
of vehicle equipment may cause
serious personal injury. The closing
procedure can be immediately
reversed by either pressing the
switch , turning the key to the
unlocking position, or pressing
button on the remote control,
and holding it.
Express Opening of Door
Windows
Press switch past resistance point
and release - window lowers to fully
open position. To interrupt procedure,
briefly press or
Note:
The power windows can also be closed
with the key or infrared remote control
while locking the vehicle doors or
trunk (see Central Locking System in
Index).
Important!
Do not close a door with the windows
fully closed while the power supply is
interrupted (battery disconnected or
empty). Doing so could damage the
window frame.
The power windows should first be
resynchronized.
After a power interruption, first
synchronize the windows to enable
activation of the soft top,
Synchronizing Power Windows
When opening a door after the power
supply was interrupted (battery
disconnected or empty), the window
will open slightly, indicating that the
Express feature should be
resynchronized.
Press side of power window
switch until the window is
completely closed and hold for
additional 2 seconds. Repeat procedure
for each window.
The automatic full opening procedure
of the windows should now be
restored.
65