JVC GM-H40L1G Instructions Manual page 27

TIMER
Item
PRESENT TIME
HOURS
MINUTES
POWER-ON SET
POWER-ON TIME
HOURS
MINUTES
POWER-OFF SET
POWER-OFF TIME
HOURS
MINUTES
reset
VCR ADJ.
Adjusts when the picture played back on a VCR is distorted. (Depending on the condition of the connected VCR or the
playback tape, the picture quality may not be improved.)
Setting value: –05 += 00 += +05
CONTROL LOCK
Activates/deactivates the Control Lock. When this function is activated, you cannot operate the monitor with the buttons on
the main unit.
Setting value: ON, OFF
NOTE
• You can use the remote control and external control while the control lock is set. To release the lock, use the remote control.
POWER ON DELAY
Sets the time when the power supply to the monitor's circuits (excluding the micro computers) starts after the power button
is pressed.
Setting value: OFF, FAST, SLOW
NOTE
• If you are going to turn several monitors on at the same time, it is recommended to apply "SLOW" to some of the monitors to control rush
current.
SYNC TERM.
Sets the resistance of Horizontal sync/Composite sync signal and Vertical sync signal when the component/RGB input card
(option) is inserted. Normally, select "HIGH" (1 kΩ). If you see pictures fl ickering or blurring on the screen because of a long
connecting cord, set this to "LOW" (75 Ω).
Setting value: HIGH, LOW
NOTE
• When a video input card (option) is inserted, "SYNC SELECT" appears. Set the sync signal to use —INT. (sync signal included in the video signal)
or EXT. (external sync signal).
To do
Sets the clock.
Sets the hour.
Sets the minute.
Activates/deactivates the power-on timer.
Sets the time to turn on the monitor.
Sets the hour.
Sets the minute.
Activates/deactivates the power-off timer.
Sets the time to turn off the monitor.
Sets the hour.
Sets the minute.
Restores the default setting for all the items in "TIMER. "
Setting value
00 += 23
00 += 59
ON, OFF
00 += 23
00 += 59
ON, OFF
00 += 23
00 += 59
27