Control 4 Wireless Doorbell Button Installation Manual

Wireless Doorbell Button

Installation Guide

for use with Control4
Mounting
Before mounting, make sure the device is in
a location where you can still push the
button to join it to the ZigBee network. If it's
in a difficult to reach place, view the
instructions for ZigBee networking and join
the device to the network before
mounting.
The Doorbell Button should be mounted
within range of the ZigBee network.
The Axxess Doorbell Button will be
mounted near the entrance door either
with screws or double-sided tape. The
housing of the Axxess Doorbell Button
consists of 2 parts, the back plate, which will
be mounted to the doorframe or wall, and
the face enclosure.
Screw Mount
Break out the 2 screw hole areas with a
screw driver.
Introduction
Axxess Doorbell Button can be installed
and configured for operation in a Control4
environment to trigger a chime unit
controlled by a Control4 interfaced device.
Typically, the chime will be controlled by
the Axxess Chime Relay.
Button can also be used as a multi-purpose
button anywhere to trigger a desired event.
Included
Doorbell Button Device
2 pcs ½ wide double sided foam tape
(base mounting)
2 mounting screws
1 Wire Harness (external magnetic
contact)
1 Wire Harness (external contact wire
leads)
The face enclosure is fastened to the back-
plate with a sliding hook at the top and a
retaining screw at the bottom end of the
face enclosure. After removing the
retaining screw, the face enclosure can be
removed by carefully pulling the bottom
out about 3/16" and sliding it up and off the
top retaining hook.
Mounting the Doorbell Button
It may be mounted by attaching the device
back plate to the desired surface either by:
1. Mounting with double sided adhesive.
2. Mounting with 2 No.4 wood screws.
Attach back plate to the wall with the 2
provided screws.
Battery and Power
This device ships with a high density AAA,
3.6V Lithium battery inserted.
The battery has unique properties, highly
superior to alkaline or Li-ion batteries, with
its high energy density and extra-wide
The Doorbell
operational temperature range.
When the device is not joined and in deep
sleep, the battery's unique chemistry
maintains the highest output quality by
periodically "exercising" for a moment. This
keeps it fresh and ready for immediate use.
We advise against removing and storing
the battery separately.
Batteries can be purchased online. A
common brand is TADIRAN. Distributors
can be found on their website.
Battery Life: 3 Years
Adhesive Mount
Peel and stick.
Attach the face by hooking the top and
tightening the retaining screw at the
bottom.