Troubleshooting - JVC HR-XV28S Instructions Manual

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power.
The power is on, but the
DVD+VCR does not
work.
No picture.
No sound.
The playback picture is
poor.
Cause
• The power cord is disconnected.
• DVD or VCR button is not switched
properly.
• No disc is inserted.
• No tape is inserted.
• The TV is not set to receive DVD+VCR
signal output.
• The video cable is not connected securely. • Connect the video cable into the jacks
• Mismatch setting between TV and this
unit.
• Wrong connection.
• The equipment connected with the audio
cable is not set to receive DVD+VCR
signal output.
• The audio cables are not connected
securely.
• The power of the equipment connected
with the audio cable is turned off.
• The AUDIO options are set to the wrong
position.
• The disc is dirty.
• The TV channels are not tuned in
properly.
• Tape heads are dirty.
• Tape is a rental or was recorded on
another VCR.
Correction
• Plug the power cord into the wall outlet
securely.
• Refer to page 5.
• Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
• Select the appropriate video input
mode on the TV so the picture from the
DVD+VCR player appears on the TV
screen.
securely.
• Select the correct Video Output in
SETUP menu.
• Check the connection.
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD+VCR.
• Connect the audio cable into the jacks
securely.
• Turn on the equipment connected with
the audio cable.
• Set the AUDIO options to the correct
position.
• Clean the disc.
• Check tuning, carry out tuning again.
• Clean video heads.
• Use PR/TRK (3/4) for manual
tracking adjustment while tape is
playing.
37