Clutch; Side Stand; Suspension - Honda VF1000F 1985 Shop Manual

MAINTENANCE
CLUTCH
Check the clutch fluid level at the clutch master cylinder
reservoir. If the level nears the lower level mark, remove the
reservoir cap, set plate and diaphragm, and fill the reservoir to
the upper level mark with DOT 4 brake fluid from a sealed
container.
Check the clutch hydraulic system for leaks if the level is low.
CAUTION
Do not allow foreign material to enter the system when
filling the reservoir.
Avoid spilling fluid on painted, plastic or rubber parts.
Do not remove the reservoir cap until the hand/ever has
been turned so that the reservoir is level.
Do
not mix different type of fluid, as they are not com-
patible with each other.
SIDE STAND
Place the motorcycle on its center stand.
Check the rubber pad on the side stand for deterioration and
wear.
Replace the rubber pad if wear extends to the wear line.
NOTE
When replacing, use a rubber pad with the mark "Over 260
Ibs ON L Y".
Check the side stand spring for damage or loss of tension.
Spring tension is correct if the measurements fall within 2-3
kg (4.4-6.6 Ibs), when pulling the side stand lower end with a
spring scale.
Check the side stand assembly for freedom of movement.
Make sure that the side stand is not bent.
SUSPENSION
tg'f.idiiiiiti
Do not ride a vehicle with faulty suspension.
Loose, worn or damaged suspension parts impair vehicle
stability and control.
FRONT
Check the action of the front forks by compressing them
several times.
Check the entire fork assembly for leaks or damage.
Replace damaged components which cannot
be
repaired.
Tighten all nuts and bolts.
3-15
(1) RESERVOIR CAP
(2) LOWER LE V EL
(1) GOOD (2) NO GOOD
LINE
o
x