Adjusting The Sound Basic Settings - JVC EXAD KD-NX901 Instructions Manual

Adjusting the sound basic settings

You can adjust the sound characteristics to your
preference.
1
2
Adjust the selected item.
Adjusting fader and balance
Adjust fader—speaker output balance between
the front and rear speakers.
• F06: Upmost—front only
• R06: Downmost—rear only
Adjust the balance—speaker output balance
between the left and right speakers.
• L06: Leftmost—left only
• R06: Rightmost—right only
86
Adjusting subwoofer output
Select an appropriate cutoff frequency level
according to the subwoofer connected.
• 115 Hz/85 Hz/55 Hz
The frequencies higher than the selected level
are cut off to the subwoofer.
Adjust the subwoofer output level.
• 00 (min.) to 08 (max.)
You can also activate or deactivate the High
Pass Filter (HPF) by pressing 3.
When it is activated, "H" is displayed in
between the output level and the cutoff
frequency. Lower frequency signals will be sent
only to the subwoofer so that you can enjoy
the low frequency effect (LFE) of the DVD
software purely from the subwoofer.
Adjusting the input level of each
source
This setting is required for each source except
FM. Before making an adjustment, select an
appropriate source for which you want to make
an adjustment.
Once you have made an adjustment, it
is memorized, and the volume level will
automatically increase or decrease by adjusted
level when you change the source.
Adjust to match the input level to the FM sound
level.
• –05 (min.) to +05 (max.)
• If you adjust it while recording a CD, the
input level of the HDD will be adjusted.