Cancelling The Display Demonstration; Setting The Clock - JVC EXAD KD-NX901 Instructions Manual

Cancelling the display
demonstration
If no operations are done for about one minute,
display demonstration starts (except when the
Navigation System is in use).
[Initial: Interval]—see page 87.
1
2
3
Select "Off."
4
Finish the procedure.
To activate the display demonstration
In step 3 above...
• Select "All Time" or
14
"Interval."

Setting the clock

The built-in clock is automatically adjusted by
receiving the GPS signals. To obtain correct
time information, it is required to set the local
time.
• When the GPS signals are received first
time after calibration (see page 11), the
clock is automatically set to the Coordinated
Universal Time (UTC).
Adjust the clock to your local time only after
it has been set to UTC.
1
2
Select "24H/12H," then select
"24Hours" or "12Hours."
3
Select "Time," then set the local time.
4
Finish the procedure.
To check the local time when the power is
turned off