Network Diagnostics - Yamaha disklavier tv User Manual

Network Diagnostics

In some cases, it may be necessary to perform network diagnostics to determine the cause
of problems. In these instances, follow the procedure below:
1
Press [FUNC.] in the RemoteLive screen.
The RemoteLive function menu screen appears.
=RemoteLive=
*Delay Adj.
*Info&Error *Diag.
2
Select "Diag." with the cursor buttons ([◄] [►] [▲] [▼]), then press [ENTER].
=RemoteLive=
*Delay Adj.
*Info&Error
The Network Diagnostics screen appears and the diagnostics start.
=Network Diag.=
Checking.
When the diagnostics process is completed, the resulting error number and message is
displayed.
=Network Diag.=
Failed to connect.(2011)
Check the cable.
3
Press [ENTER] to complete the operation.
Error Messages
Number Message
0000 Network OK.(0000)
2011 Failed to connect.(2011)
Check the cable.
2012 Failed to connect.(2012)
Check Network setting.
2013 Failed to connect.(2013)
Check DNS setting.
2014 Failed to connect.(2014)
DNS is not available.
2015 Failed to connect.(2015)
Check Proxy setting.
2010 Failed to connect.(2010)
Cannot connect to server.
(1/1)
*Pedal Adj. "Pedal Adj." appears on Disklavier E3 only.
(1/1)
*Pedal Adj.
*Diag.
ENT
Error number and message
Remedy
No problem.
Make sure that your Disklavier is connected properly to network with
a network cable.
Make sure that the IP address of your Disklavier has been set
correctly.
Make sure that the DNS server address has been set correctly.
Make sure that the overall network settings (DHCP setting, DNS
server address, IP address, subnet mask and gateway server
address) on your Disklavier have been set correctly. If the problem
persists, please contact your internet service provider.
Make sure that the proxy server has been set correctly.
The RemoteLive server may be temporarily down for maintenance.
Please try again later.
DisklavierTV User's Guide (For Disklavier E3 and DKC-850 Users)
Appendix
32