To Use The Remote Control Unit For Tv Operation - JVC XV-511BK Instructions Manual

To use the remote control unit for TV operation

You can operate your TV from the remote control unit.
Setting the remote control signal for operating your TV.
1
Holding down TV/VIDEO, enter the manufacturer code of your TV listed below by using the numeric buttons (0 - 9).
Do not release TV/VIDEO. Keep holding it until the next step is completed.
Manufacturer code list
No. Manufacturer
01 JVC
02 MAGNAVOX
03 MITSUBISHI
04 PANASONIC
05 RCA
06 SHARP
07 SONY
08 TOSHIBA
09 ZENITH
10 HITACHI
11 PANASONIC
12 SAMSUNG
13 SANYO
14 SANYO
15 SAMSUNG
2
Press STOP while holding down TV/VIDEO.
The following buttons can be used for operating the TV:
Turns the TV on or off.
TV POWER
+
Changes the TV channels.
TV ch
–
+
Adjusts the TV volume.
TV VOL.
–
Selects the TV channels
(while holding down the SHIFT button).
to
0 9 *For some TVs, pressing "+10" while holding down SHIFT
functions as the "+100," and pressing "10" while holding down
SHIFT functions as the "RETURN" button.
TV/VIDEO
Switches input mode (either TV or VIDEO).
3
Try to operate your TV by pressing TV POWER.
If your TV turns on or off, you have successfully set the control signal.
NOTE
• The remote control unit is initially set for operating a JVC TV.
• If there is more than one code listed for the manufacturer of your TV, try them one by one until you succeed.
Example:
To enter the manufacturer code "01":
Press "0" then "1."
Getting started
16