Advertisement
Available languages
Available languages
3G Modem USB Internal
All rights reserved; no part of this publication may be reproduced, stored in a retrieval system, or
trasmitted in any form or by any means, electronic, otherwise, without the prior written permission
of Digicom S.p.A.The contents of this booklet may be modified without notice. Every possible care
has been taken in testing and putting together all the documentation contained in this booklet,
however Digicom S.p.A. can not take any responsability brought by the use of this booklet.
PREFACE
In order to guarantee your safety and a correct functioning, be sure to follow these safety
warnings. The whole set (with cables included) must be installed in a place lacking of or
distant from:
• Dust, humidity, high temperatures and direct exposure to sunlight.
• Heat irradiating objects, which may damage your device or cause any other problem.
• Objects producing a high electromagnetic field (Hi-Fi speakers, etc.).
• Corrosive liquids or chemical substances.
ENVIRONMENTAL CONDITIONS
Environment temperature: from 0 °C to +55 °C
Relative humidity: from 20 to 80 % n.c.
CLEANING INFORMATION
Use a soft dry cloth and avoid any solvents or abrasive materials.
SHOCKS OR VIBRATIONS
Caution against shocks or vibrations.
SAFETY WARNINGS
Read these instructions and norms carefully before powering the device. Violation of such
norms may be illegal and cause hazard situations. For any of the described situations please
refer to the specific instructions and norms.
The device is a low power radio transmitter and receiver.When it is ON, it sends and receives
radio frequency (RF) signals.
The device produces magnetic fields. Do not place it next to magnetic supports such as
floppy disks, tapes, etc.
Operating your device close to other electrical and electronic equipment - such as a television,
phone, radio or a personal computer - may cause interferences.
INTERFERENCES
The device, like all other wireless devices, is subject to interferences that may reduce its
performances.
ROAD SAFETY
Do not use your device while driving. In case of use on cars, you must check that the
electronic equipment is shielded against RF signals. Do not place the device in the air bag
deployment area.
AIRCRAFT SAFETY
Switch off your device when on board aircrafts by disconnecting the power supply and
deactivating the internal backup battery. Using GSM devices on aircrafts is illegal.
HOSPITAL SAFETY
Do not use the device near health equipment, especially pacemakers and hearing aids, in
order to avoid potential interferences. Take care when utilizing the device inside hospitals
and medical centres, which make use of equipment that could be sensitive to external RF
signals. Switch it off when use is expressly forbidden.
EXPLOSIVE MATERIALS
Do not use the device in refuelling points, near fuel or chemicals. Do not use the device
where blasting is in progress. Observe restrictions and follow any specific regulation or
instruction.
5
DECLARATION
We, Digicom S.p.A., with registered office at Cardano al Campo (VA - Italy) - Via Volta 39,
declare under our sole responsibility, that the products named 3G Modem USB Internal, to
which this declaration refers to, satisfy the essential requirements of following Directive:
- 1999/5/CE 9th March 1999, R&TTE (concerning radio equipment and telecommunication
terminal equipment and the acknowledgment of their conformity) Law Decree 9th May
2001, n.269, (G.U. n. 156 of 7-7-2001).
As indicated in conformity with the requirements of following Reference Standards or
of other regulations documents:
- EN 301 489-1
- EN 301 489-7
- EN 55022
- EN 55024
- EN 301 511
- EN 60950-1
ASSISTANCE AND CONTACTS
Most of questions can be answered by looking up in the Support > F.A.Q. section of our
website at www.digicom.it.
If you can't find the answer you're looking for, please contact our Technical Support at
support@digicom.it
7
INSTRUCTIONS FOR USE
Do not use the device in direct contact with the human body and do not touch the antenna
if not strictly necessary.
Use approved accessories only. Consult documentation regarding any possible device
connected to the device. Do not connect incompatible products.
INFORMATION FOR USERS
According to the 2002/95/CE, 2002/96/CE and 2003/108/CE Directives, relative to reduction
in the use of hazardous substances in electrical and electronic apparatus, as well as to
disposal of waste materials.
The symbol of a crossed box applied on the apparatus or on its package indicates
that at the end of its useful life the product must be collected separately from
other waste materials.
The user must therefore take the apparatus which has reached the end of its
useful life to appropriate separate collection centres for electronic and electro-
technical waste materials, or deliver it back to the reseller when purchasing new
apparatus of an equivalent type, giving one piece in for one piece out.
Suitable separate waste collection for then sending the cast-off apparatus for recycling,
treatment and environmentally friendly disposal, contributes towards preventing any possible
negative effects on the environment and on health and encourages recycling of the materials
the apparatus is made up of.
Unauthorised disposal of the product by the user will lead to payment of the administrative
sanctions in force in the country where it is put on the market.
OF CONFORMITY
Quick Guide
6
8
Advertisement
