Loading Labels - Dymo LabelWriter 400 Turbo Quick Start Manual

4. Loading Labels

To load a label roll
Press the form-feed button to eject the labels that
1
protected the printer during shipment.
Open the top cover and remove any packing
2
material inside the label compartment.
Remove the label spool from inside the cover.
3
Hold the spool spindle in your left hand and place the
4
label roll on the spindle so that the labels feed from
underneath and the left edge of the label roll is flush
against the side of the spool. See Figure 7.
Place the spool guide onto the right side of the spool
5
and press the guide tightly against the side of the
label roll, leaving no gap between the roll and the spool. See Figure 8.
The label roll must fit snugly against both sides of the
NOTE
label spool, with no gaps, to avoid drifting as the labels feed
through the printer.
Insert the label spool into the slot in the printer cover with
6
the labels extending from underneath the roll. See Figure 9.
Spool
Spool
guide
spindle
Figure 7
Figure 8
Figure 9
5