Download
Share
Print this page
MTD Jet sweep blower Operator's Manual
  1. Manuals
  2. Brands
  3. MTD Manuals
  4. Blower
  5. Jet sweep blower
  6. Operator's manual
MTD Jet sweep blower Operator's Manual

MTD Jet sweep blower Operator's Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
O
'
M
peratOr
s
anual
Jet Sweep Blower
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA
Form No. 769-07503
(September 15, 2011)

Advertisement

loading

Related Manuals for MTD Jet sweep blower

Summary of Contents for MTD Jet sweep blower

  • Page 1 READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 Printed In USA Form No. 769-07503...

  • Page 2: Table Of Contents

    Choose from the options below: ◊ Visit us on the web at www.mtdproducts.com ◊ Call a Customer Support Representative at (800) 800-7310 or (330) 220-4683 ◊ Write to MTD LLC • P.O. Box 361131 • Cleveland, OH • 44136-0019...

  • Page 3: Safe Operation Practices

    Important Safe Operation Practices WARNING! This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
  • Page 4 If your machine should start making an unusual noise or Remove gas-powered equipment from the truck or vibration, immediately stop the engine, disconnect the trailer and refuel it on the ground. If this is not possible, spark plug wire and move the wire away from the spark then refuel such equipment on a trailer with a portable plug.

  • Page 5: Safety Symbols

    Spark Arrestor According to the Consumer Products Safety Commission (CPSC) and the U.S. Environmental Protection Agency (EPA), WARNING! this product has an Average Useful Life of seven (7) years, This machine is equipped with an or 70 hours of operation. At the end of the Average Useful internal combustion engine and should not be used Life have the machine inspected annually by an authorized on or near any unimproved forest-covered, brush-...

  • Page 6: Assembly & Set-Up

    • One Upper Handle • One Chute Attachment • One Jet Sweep Blower Operator’s • One Engine Operator’s Manual Manual NOTE: All references to the left or right side of the jet sweep Place the upper over the lower handle, aligning the upper blower are from the operator’s position.
  • Page 7 WARNING! To redirect airflow at a 90 degree angle during operation, a chute Use extreme care when handling attachment is included with your jet sweep blower. gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine Pivot the blower direction lever all the way to the right, into indoors or while the engine is hot or running.

  • Page 8: Controls & Features

    Blower Housing Blower Direction Lever Discharge Chute Figure 4-1 Blower Direction Lever Jet Sweep Blower controls and features are illustrated in Fig 4-1 and described below. AIR FLOW The air flow can be directed to one WARNING! Read and follow all safety rules and...

  • Page 9: Operation

    Operation Starting & Stopping the Engine Refer to the Engine Operator’s Manual for instructions on starting and stopping the engine. Adjusting the Blower Direction The air flow can be directed to one of three directions using the blower direction lever to move the louvers. NOTE: The blower direction lever must be in the middle position when operating the blower with the chute attachment to keep it locked in place.

  • Page 10: Maintenance & Adjustment

    Maintenance & Adjustments Maintenance WARNING! Before performing any maintenance or repairs always stop engine. Engine Refer to the Engine Operator’s Manual for all engine maintenance procedures and instructions. Cleaning the Blower Any fuel or oil spilled on the machine should be wiped off promptly.

  • Page 11: Replacement Parts

    Replacement Parts Component Part Number and Description 951-10292 Spark Plug 951-10794 Air Filter 951-10651 Fuel Filter 734-2004B Wheel (Front) 734-04093 Wheel (Rear) 951-12535 Fuel Tank Cap 631-04253 Discharge Chute w/ Label 781-04175 Discharge Chute Base 710-04373A Discharge Chute Screws (3x) 720-04091 Foam Grip (800) 828-5500 or (330) 558-7220...

  • Page 12: Warranty

    MANUFACTURER’S LIMITED WARRANTY FOR The limited warranty set forth below is given by MTD LLC with c. Service completed by someone other than an authorized service respect to new merchandise purchased and used in the United States dealer. and/or its territories and possessions, and by MTD Products Limited d.