Removal Of Speedometer Drive Gear, Governor Body And Governor Hub; Removal Of Converter Housing, Oil Pump, Reverse And Second Clutch Assembly - Opel 1900 1973 Service Manual

3. Remove extension housing and gasket. See Figure
Figure
4. Remove parking paw1 actuator rod from transmis-
sion case.
Removal of Speedometer Drive Gear, Governor
Body and Governor Hub
1. Depress speedometer drive gear retaining clip and
remove speedometer drive gear by sliding off output
shaft. See Figure 7C-125.
Figure 7C-125
2. Remove the four (4) attaching bolts from the gov-
ernor body and remove governor and gasket. See
Figure 7C-126.
A U T O M A T I C T R A N S M I S S I O N
Figure 7C-126
3. Remove governor hub snap ring from output shaft
using snap ring pliers, such as J-8059. See Figure 7C-
128.
Figure 7C-128
4. Slide governor hub off the output shaft
Removal of Converter Housing, Oil Pump, Reverse
and Second Clutch Assembly
1. Turn transmission in holding fixture so that con-
verter housing is facing up.
2. Remove the seven converter housing attaching