DEC 4000 Model 200 Operation Manual page 19

position. Before you can enter console commands, press the Halt button
again to return it to the out position. When the Halt button is returned
to the out position, the console mode prompt (>>>) is displayed on the
console terminal screen. Now you can enter console commands. If you
inadvertently press the Halt button, enter c
describes halting the system in more detail.
CAUTION: Pressing the Halt button halts the system regardless of the
setting of the Break Enable/Disable switch on the CPU cover panel.
Below the Halt button is the Restart button. The Restart button has a
green indicator. When you press the Restart button, the system returns to
a power-up condition and self-tests are run. If you have specified a device
as the boot device and if the Break Enable/Disable switch is set to disable,
the system will reboot system software. Further instructions on restarting
your system are in Chapter 2.
NOTE: The Halt and Restart buttons can be disabled to prevent accidental
activation. Contact your Digital service representative if you want to disable
the controls on the SCP.
to continue. Chapter 2
Return
System Overview 1–9