Indoor Dome With Safety Lanyard Installed On Lower Dome At Factory; Figure 5: Installation, Lower Dome With Safety Lanyard Installed At Factory On Lower Dome - Honeywell UltraDome KD6i Series User Manual

3.1 LOWER DOME MODULE INSTALLATION, CONTINUED
3.1.2

Indoor Dome with Safety Lanyard Installed on Lower Dome at Factory

1. Locate the safety lanyard on the bottom dome.
2. Slide the ball on the lanyard into the clip on the top dome as shown in the
illustration.
3. For installations requiring CE compliance, perform the following steps, otherwise,
go to step 4.
4. Align the bottom dome with the top and twist to lock the bottom dome brackets
over the mounting posts. For CE compliance, tighten the lock screw in the bottom
dome with the 5/64" hex key until it is snug. DO NOT OVERTIGHTEN.
SAFETY LANYARD
TRIM RING

Figure 5: Installation, Lower Dome with Safety Lanyard Installed at Factory on Lower Dome

Rev. D
a. Locate the bag containing a lock screw and 5/64" hex key (supplied with
the bottom dome).
b. Insert the 2-56 lock screw through the hole in the bottom dome trim ring
and screw it into the bottom dome inner ring.
CLIP
SAFETY CABLE
LOWER DOME
LOWER DOME
MOUNTING POSTS
(3 PLACES)
MOUNTING TABS
HOOK ON POSTS
IN BACK CAN
(3 PLACES)
2-56 CAPTIVE SCREW
(CE COMPLIANCE FOR
INSTALLING LOWER
DOME)
15 KDMU000799
02/6/04